Views: 0 Author: Site Editor Publish Time: 2022-09-28 Origin: Site
What is the new method for debugging small sewage treatment equipment? Come and read today's article with the editor. I believe that after reading it, everyone will understand.
1. After the sewage treatment equipment is installed, first open the water inlet valve and the water outlet valve to transport the sewage to the sewage treatment equipment.
2. After the water level reaches 1/2 of the height, open the fan inlet valve, turn on the fan, slowly open the fan outlet valve, and aerate the contact oxidation tank for 48 hours, then start the sewage treatment equipment inlet water lift pump to remove the sewage. Add to 3/4 of the equipment, and then aerate the pool for 24 hours.
3. Observe the production of microorganisms in the water. If there is a layer of orange-yellow biofilm, continue to transport sewage and gradually increase the amount of water. Observe the growth of microorganisms in the sewage treatment equipment.
4. The operator of the sewage treatment equipment must observe the situation of the sewage treatment equipment, discharge the sludge every 24 hours, and use the sludge discharge operation in the sewage treatment equipment.
5. Add disinfectant to the disinfection pool according to the requirements. After the equipment is debugged and running normally, the system can enter into automatic operation.
Today's article on small sewage treatment equipment is like this. You can continue to pay attention to our website. We will continue to organize more and better articles to share with you. See you in the next issue.